Venhill U01-1-200 Universal Motorcycle Braided Stainless Steel Clutch Cable Kit

High-quality, "build-your-own" cable kit suitable for any motorcycle clutch application.One end of the inner wire is fitted with a barrel nipple (nominally 6mm dia x 10mm). The opposite end will need to be cut to length and the required nipple soldered into place.PLEASE NOTE: We strongly discourage the use of a propane type torch to heat and flow solder into the wire. This is likely to overheat the wire, causing it to become brittle and break. We recommend immersing the wire ends in a molten solder bath, such as that in a solder pot.The chrome ferrules and bends are a snug fit. They may be bonded into place if preferred.The Kit Includes:2 meters (6.5 feet) of braided stainless steel outer conduit2 meters (6.5 feet) of 2mm OD galvanized steel wire (1 x 19 strand)3 chrome plated ferrule bends4 chrome plated ferrules1 chrome plated adjuster assembly1 chrome plated mid-adjuster assembly1 brass barrel nipple (5/16" x 5/16", 2mm bore)1 brass barrel nipple (3/16" x 3/16", 1.9mm bore)1 brass trumpet nipple (6mm -> 3.5 OD, 2.5mm ID, 9.5mm length)

• High-quality, "build-your-own" cable kit suitable for any motorcycle clutch application.
• Whether you're building a custom chopper, dressing up your classic, have a one off show project, or outfitting a race bike, Venhill kits will serve you well.
• PLEASE NOTE: This braided stainless cable kit is optimized for metric fitments and include fittings appropriate for Yamaha type controls. Please refer to kit specs below to determine if this kit will work for your application.
• The conduit is Teflon lined spiral wound steel covered with PVC, then our stainless braid, which is then coated by a crystal clear PVC protective coating.
• The Teflon liner provides smooth action and zero maintenance & the wire is galvanized steel for long life and easy soldering.